Programming Your Remote Control

For additional settings and information, please visit wavebroadband.com.

Auto Search Method

Your cable remote may be used to control other devices within your entertainment system. You can use the Auto Search Method to find the correct code number for your equipment by following the steps below:

STEP 1 Turn on the equipment you wish to operate with the remote.

STEP 2 Press the device button (TV, VCR, DVD, or AUX) to be programmed and the [OK/SELECT] button simultaneously for 3 seconds. The device button LED will turn on.

TIP: The device button LED will turn on for 30 seconds. The next step must be entered while LED is on.

STEP 3 Point the remote toward the equipment and press the [CH+] or [CH-] button one at a time or keep it pressed. The remote will emit a series of power on/off commands. Release the [CH+] or [CH-] button as soon as the equipment turns off.

TIP: You can verify that you selected the correct code by pressing the [POWER] button. The equipment should either turn on or off.

STEP 4 Press the same device button to store the code. The device button LED will blink twice to confirm that the code has been stored.

It is possible to manually enter a code that directly corresponds to the brand of your device. Refer to the instruction manual that came with your remote, or to view the manual online, please visit wavebroadband.com.

Programming Volume Control

By following the steps below, you can program the volume controls (Volume Up and Volume Down) from one device to operate in another device mode. The default volume control settings on the remote control are as follows:

CBL: TV               TV: TV            VCR: TV

DVD: TV               AUX: AUX

If you wish to store the TV volume control in CBL mode, use the following steps:

STEP 1 Press the [CBL] button and the [OK/SELECT] button simultaneously for 3 seconds. The [CBL] device LED will turn on.

TIP: The device button LED will turn on for 30 seconds. The next step must be entered while LED is on.

STEP 2 Press the [VOL+] button.

STEP 3 Press the [TV] button. The device LED will blink twice to confirm the programming.

To return to the original state:

If you wish to restore the CBL volume control to CBL mode, repeat the above steps by pressing [CBL] in STEP 3.

Programming for Advanced Function

In the CBL mode, the M [MACRO] button can be programmed to act as a macro or favorite channel button. You can program up to three separate channels that can be accessed with a simple press of the M button.

STEP 1 Press the [CBL] button to select the CBL mode on your remote.

STEP 2 Press the [M] button and [OK/SELECT] button simultaneously for 3 seconds. the [CBL] device LED will turn on for 30 seconds.

STEP 3 Enter the 3 or 4-digit channel number you want programmed first (for example, 007) using the Number Pad, then press the [STOP] button. Then enter the code for the next channel (for example, 050), then press the [STOP] button. Repeat this process for the third channel. The [CBL] button will blink once for each channel entered.

STEP 4 Press the [CH+] button to store the functions that were selected. The [CBL] device LED will blink twice to confirm storage of the functions.

Low Battery Warning

When the batteries are low and need to be replaced, the remote control LED will blink 2 times in sequence whenever a [POWER] button is pressed to turn on equipment.